AC-DA2012A
- Fully compatible with all external filters
- Improves the quality of water
- Improves the taste of the water
- Reduces undesirable substances
- Reduces chlorine
- BPA Free
Detail
Specifications
- Name: AC-DA2012A
- Replacement for: All external filters
- Capacity: 5678 litres
- Flow: 1.9 – 3.8 LPM
- Operating temperature: 1 °C – 37.8 °C
- Working pressure: 206 kPa (30 psi) – 827 kPa (120 psi)
- Dimensions: 25.5 x 5.1 cm
- Service life: 6 months
Installation manual
- Close the water supply.
- Dispose the remaining water from the refrigerator.
- Remove the old filter from hose.
- Cut the hose at both ends (approx. 12-15 mm)
- Firmly push the water hose (connected to the water supply) into the end of the filter, which is marked with an inward arrow.
- Push the hose in as far as it will go (approx. 12-15 mm) and secure with a coupling.
- Dispose approximately 15 litres of water from the filter (until the water flows crystal clear).
- Close the water supply.
- Firmly push the water hose (connected to your refrigerator) into the end of the filter, which is marked with an arrow pointing outwards.
- Push the hose in as far as it will go (approx. 12-15 mm) and secure with a coupling.
- Make sure the hose is firmly held at both ends of the filter.
- Open the water supply.
- Reset the led indicator on your refrigerator to indicate that the filter has been replaced (according to the instructions provided with your refrigerator).
CAUTION: Check the direction of water flow (marked with an arrow) on the filter or on the filter box. (Water supply ——> Fridge)
CAUTION: Always check the filter area for water leaks.